right so done my m52 conversion a few years ago but the steering knuckle (on end of steering column to rack) is very close to exhaust manifold.
anyone had any luck with trying parts from other models?
basically i need to eliminate the rubber disc or move it to a lower position.
steering knuckle
Re: steering knuckle
Will it help if you flip it upside down? I’m mocking up my engine (slowly) and was thinking of trying that.
Otherwise I seen a conversion thread that I think was on here where they had a straight bar with no rubber disc made up.
Otherwise I seen a conversion thread that I think was on here where they had a straight bar with no rubber disc made up.
Re: steering knuckle
Swapping the middle round is possible.
You have to press out the UJ joints (there is an art to doing this).
Swap round the middle
Regrease and press it back together, trying to keep all the roller pins in place.
Final thing this is to re-stake the uj's to stop them coming apart on their own.
HTH
Ben
You have to press out the UJ joints (there is an art to doing this).
Swap round the middle
Regrease and press it back together, trying to keep all the roller pins in place.
Final thing this is to re-stake the uj's to stop them coming apart on their own.
HTH
Ben
1982 323i (S54 "Test Mule" - to be rebuilt into M20 powered track car)
1983 316 (Taiga Thunder - The refined S54 Race car)
1982 635csiA (New project)
1985 728iA (For Sale)
2004 330d Touring (The Daily Hack / Tow Car / Load lugger)
1983 316 (Taiga Thunder - The refined S54 Race car)
1982 635csiA (New project)
1985 728iA (For Sale)
2004 330d Touring (The Daily Hack / Tow Car / Load lugger)