Page 2 of 5
Posted: Sun Aug 30, 2009 1:51 pm
by --ALPINA--
Oh ok, nice project pat from norway....
Posted: Mon Dec 07, 2009 2:20 am
by 340i
looks like a good project and a very good car to build up. im not sure if this will help with your 6 but it did with my engine swap - to make it easier to get the motor in/out i cut out the metal infront of where the radiator is and made it into a bolt in panel. it depends how many times you'll have it in and out of course though...
Posted: Mon Dec 07, 2009 5:47 am
by Zul-Azrin
Wonderful work and PLEASE keep on updating your progress...
320/6
Posted: Mon Dec 07, 2009 2:12 pm
by Davebv
Keep up the good work in NORWAY !!
Please don't forget to make pictures and share them with us
Posted: Mon Dec 07, 2009 4:33 pm
by bmw pat
Here are some new pictures. Not the best quality. I am in the process of removing all the old paint from the bodyshell. Most part of it is now down to bare metal, also the underside of the car. Then I start welding in some new panels. I am going to change the forward section of the inner wing on both sides in the front, complete frontpanel, complete back panel and rear lower quarterpanel on both sides.
Posted: Mon Dec 07, 2009 9:39 pm
by 340i
wow. nice. what did you use to strip the car?
Posted: Mon Dec 07, 2009 10:47 pm
by bmw pat
I am using a eletrical scraper to remove the undersealant, and a orbital sander to remove the paint. I finish off with sand blasting.
Posted: Mon Dec 07, 2009 11:07 pm
by 340i
whats an electrical scraper?
Posted: Mon Dec 07, 2009 11:17 pm
by bmw pat
This is what i call an eletric scraper. It may have another name in english
Posted: Mon Dec 07, 2009 11:43 pm
by E21meister
Interesting. The answer to everyone's underseal scraping nightmares...
Posted: Thu Dec 10, 2009 1:49 pm
by bmw pat
Finished sandblasting my engine compartment and inner wings
Posted: Thu Dec 10, 2009 8:10 pm
by bmw pat
Posted: Fri Dec 11, 2009 8:19 pm
by bmw pat
Desided to change the left inner wing, so i started with that this afternoon.
Posted: Fri Dec 11, 2009 11:04 pm
by E21meister
Good reference pictures for everyone if you're fitting different engines, modding suspension etc.
Posted: Sat Dec 12, 2009 11:47 am
by Zul-Azrin
Did you sandblasted the car yourself? Can you give me the sandblasting set up: pressure,blasting media etc etc...please
Thanks