Page 6 of 23
Posted: Sun Jan 24, 2010 1:06 pm
by e21-Mark
--ALPINA-- wrote:That dash pod should have come in the right hand drive cars also, cos id definetly want one like it!!!!, how much was that dashpod??
And also have you got a link to the website where you got it from!!
J
Ask Darren about the pod solution in one of his mags. Sounds like a cracking idea and I think I might try it myself.
Posted: Sun Jan 24, 2010 1:08 pm
by Jacko
Someone should buy one of these, and flip it over so its for RHD cars as i'd love one. Any chance of getting the CADs i wonder...
Posted: Sun Jan 24, 2010 2:46 pm
by --ALPINA--
RetroBeemer wrote:Ask Darren about the pod solution in one of his mags. Sounds like a cracking idea and I think I might try it myself.
mark, what you mean pod solution? i was thinking of ordering one and get someone/company to reverse it if they can!
J
Posted: Mon Feb 08, 2010 8:03 am
by DC
I have found few spare minutes and installed Recaro seats and VDO console
Posted: Fri Feb 26, 2010 8:22 pm
by DC
I don´t have time this month, so I am just buying things
big old M10 starter, small new one from S14 and old M40 one for comparison
starter from S14 is now in the car
engine dampers from hard rubber
and biggest improvement - new ECU from extraEFI - I´ll have setup with fuel control and distributorless COP ignition
Posted: Fri Feb 26, 2010 10:37 pm
by e21-Mark
Good work mate.
Posted: Sun Feb 28, 2010 7:20 am
by DC
Posted: Sun Feb 28, 2010 3:16 pm
by E21meister
Posted: Sat Mar 13, 2010 7:20 am
by DC
now I am renewing front brakes and LSD is finally installed on the car. I am loooking forward to the test drive with LSD and then I´ll cut out L-jetronic and install Megasquirt II Extra
Posted: Sat Mar 13, 2010 9:41 am
by e21-Mark
Good work. LSD makes things so much better.
Posted: Sat Mar 13, 2010 9:10 pm
by DC
change of order
L-jetronic is history
Megasquirt incoming
Posted: Fri Mar 19, 2010 6:43 pm
by DC
I made some progress and here is result - 75% work done ->
distributor is gone to make place for COP ignition
trigger wheel ready
Posted: Fri Mar 19, 2010 7:32 pm
by tommi_e21
can you take some pics of how you mount you trigger sensor, where did you get the wheel from? jason is hopefully supplying mine from massive brakes.
love the penci coils but be careful about the heat from the exhaust, could effect it
Posted: Fri Mar 19, 2010 7:45 pm
by DC
I bought sensor holder from 02again.com
http://www.02again.com/product_info.php/products_id/157
wheel is from trigger-wheels.com
and also coil holder from 02again.com
this should hold coils and take care of heat
Posted: Wed Mar 24, 2010 6:54 am
by DC
85% ready, coils are wired in, I need their holder and crank sensor holder and trigger wheel
