Page 1 of 1
front wheel bearings... differ from 316 to 323 ?
Posted: Sat Jul 10, 2010 1:12 pm
by myfirstE21
hi all,
just bought some front wheel bearings for my 316 but they are too small, i think i may have a 323 front end on it?
how can i tell?
cheers
steve
Posted: Sat Jul 10, 2010 1:37 pm
by e21-Mark
Have you got vented discs? Measure the strut diameter.
Posted: Sat Jul 10, 2010 2:18 pm
by myfirstE21
yep i have vented discs, and the strut diameter is about 54mm on the outside?
does this mean i have a 323 front end
cheers
steve
Posted: Sat Jul 10, 2010 2:19 pm
by tommi_e21
yup
good times
Posted: Sat Jul 10, 2010 2:27 pm
by myfirstE21
why is it better? because of the vented brakes?
now ill have to go swap my new bearings for 323 ones lol
also there is some new front shock inserts in the boot of my car i assume they wont fit if they for a 316
?
Posted: Sat Jul 10, 2010 3:47 pm
by e21-Mark
No, but I can sell you some and I have lowered springs and rear shocks too!
Posted: Sat Jul 10, 2010 4:02 pm
by myfirstE21
my car already has lowered springs on it and im loking to put coilovers on the the future, but how much u looking for the shocks and what make are they?
Posted: Sat Jul 10, 2010 4:06 pm
by e21-Mark
It's a complete set-up mate so won't be splitting it up - sorry.
Posted: Sat Jul 10, 2010 5:59 pm
by myfirstE21
how much for the lot?
Posted: Sat Jul 10, 2010 6:45 pm
by e21-Mark
£250
Posted: Sat Jul 10, 2010 7:27 pm
by myfirstE21
think ill pass on them mate and keep saving for some GAZ coilies