Page 1 of 1
323i rear badge
Posted: Thu Sep 09, 2010 10:14 am
by Mcinek
Hi!
I got new boot lid but with no holes for the 323 badge. Can anybody help and tell where do I need to drill holes. As you can see on the picture below I need 8 positions.
Regards
Marcin
Re: 323i rear badge
Posted: Thu Sep 09, 2010 10:26 am
by Jeroen
Marcin,
If I were in your shoes I'd remove the pins from the badge and just use double sided tape, no drilling!
Re: 323i rear badge
Posted: Thu Sep 09, 2010 12:22 pm
by tommi_e21
leave it with no badge, looks much smoother, but if not i agree with the sticking it on idea
Re: 323i rear badge
Posted: Thu Sep 09, 2010 2:57 pm
by tyson 320i/323i
i third the idea of using double sided tape. or you could just not put a badge on the lid. the u.s. spec 320 is' had no badge on the trunk lid
Re: 323i rear badge
Posted: Thu Sep 09, 2010 4:34 pm
by Mcinek
Maybe the double sided tape is the best option, that is what I will probably do.
Thanks.