Page 1 of 1
switch replacing question
Posted: Thu Mar 17, 2011 8:22 am
by petroscf
Ok, I 've asked this again somewhere else but did not get any reply.
Can anyone tell me whether I could properly fit a second lighter-12v connector on my dash, where the front foglights switch exists today?
Re: switch replacing question
Posted: Sun Mar 20, 2011 6:15 pm
by Danny043
Sure, but be aware of the fuse you connect it to, you might need a higher rated one.
I don't know what you want to use it for, but the lighter might get too hot. The one in the dash has a lot of room around it, if I remember correctly.
Re: switch replacing question
Posted: Mon Mar 21, 2011 9:17 am
by petroscf
Actually my thoughts are to use this as an ac connector and not as a lighter (not a smoker anyway)
As I am going to remove the front foglights switch (when I fit the BBS front air dam, there 'll be no room for the foglights), I was thinking that the need to charge various appliances, and similtaneously, sometimes, increases year by year (mobile phones, GPS, mp3 players, bluetooth handsfree handsets etc.). So I think that a second ac connector might be of more use than anything else