Page 1 of 1
m10 gearbox onto m20 auto engine?
Posted: Thu Jul 28, 2011 9:31 am
by pilly
I thought there might have been something on here about this but i have searched to no avail.
Right here's the question.... Can the m10 gearbox (not sure of proper name Getrag....) fit onto an m20 engine which was an auto.
If this is possible how would the tail shaft length be??
Thanks
Re: m10 gearbox onto m20 auto engine?
Posted: Thu Jul 28, 2011 9:41 am
by e21-Mark
No, the bellhousing pattern/size is all wrong. A manual box from an m30 engine will fit but you'll need to make the tunnel bigger to fit it in.
Re: m10 gearbox onto m20 auto engine?
Posted: Thu Jul 28, 2011 12:22 pm
by drjim
M30 fits M10 rather than M20 so far as I was aware - Mark are you mixed up or misunderstyping?
Re: m10 gearbox onto m20 auto engine?
Posted: Thu Jul 28, 2011 1:03 pm
by e21-Mark
misundertyping. That's what I meant, yes.
Re: m10 gearbox onto m20 auto engine?
Posted: Fri Jul 29, 2011 9:10 am
by pilly
mmm.... ok i guess i shall have to live with 4 cylinders.... its way to much hassle to get any new parts that i don't have..
Thanks anyway!!
Re: m10 gearbox onto m20 auto engine?
Posted: Fri Jul 29, 2011 11:14 am
by tommi_e21
4 cylinders is better than 6!!!!!
Re: m10 gearbox onto m20 auto engine?
Posted: Fri Jul 29, 2011 11:30 am
by e21-Mark
and then you woke up and had cornflakes!
