Rev counter wiring
Posted: Mon May 28, 2012 7:14 am
Hi all
I'm trying to replace the clock in my 1981 316 dash with a rev counter, and I was just wondering if anyone has any idea how to connect the terminals?
They are labeled:
31
1
R
and a separate connecter labeled:
30
58
I think these 2 are for the digital clock, but i'm not sure which is +, and which is -, can i plug in the wires from the analogue clock into them?
From the haynes manual, I am assuming (as no terminal labels on schematic) that 31 is +, 1 is from - terminal on the coil, and R is -earth?
Should the loom already be in place? there are 2 additional plugs taped to the loom, one black wire and the other is a 2 wire connecter which seems
to plug into a connector on the fuel gauge side right at the very top on the new dash panel.
Any help would be really appreciated!!
I'm trying to replace the clock in my 1981 316 dash with a rev counter, and I was just wondering if anyone has any idea how to connect the terminals?
They are labeled:
31
1
R
and a separate connecter labeled:
30
58
I think these 2 are for the digital clock, but i'm not sure which is +, and which is -, can i plug in the wires from the analogue clock into them?
From the haynes manual, I am assuming (as no terminal labels on schematic) that 31 is +, 1 is from - terminal on the coil, and R is -earth?
Should the loom already be in place? there are 2 additional plugs taped to the loom, one black wire and the other is a 2 wire connecter which seems
to plug into a connector on the fuel gauge side right at the very top on the new dash panel.
Any help would be really appreciated!!