Page 1 of 1
temp & tacho
Posted: Tue Oct 09, 2012 6:10 pm
by harleytrike
my temp gauge and tacho have stopped working checked all the fuses and replaced them any ideas
Re: temp & tacho
Posted: Tue Oct 09, 2012 6:25 pm
by Jeroen
Focus on fuse 14, does it have 12V? Reverse lights working? Also see
http://www.bmwe21.net/?page_id=130
Re: temp & tacho
Posted: Tue Oct 09, 2012 6:32 pm
by harleytrike
fuel gauge is still working and reversing lights still working
Re: temp & tacho
Posted: Tue Oct 09, 2012 7:07 pm
by Jeroen
Weird!
Re: temp & tacho
Posted: Tue Oct 09, 2012 7:26 pm
by harleytrike
that helps lol
Re: temp & tacho
Posted: Tue Oct 09, 2012 10:22 pm
by cobbler2u
Try another set of clocks.
Takes about 5 mins to change add will show if clocks are ok or not
Goodluck
Re: temp & tacho
Posted: Tue Oct 09, 2012 10:51 pm
by harleytrike
clocks are perfect but tried another set still nothing
Re: temp & tacho
Posted: Wed Oct 10, 2012 2:12 pm
by nas80
Id change the whole binacle rather than just the rev gauge.
Re: temp & tacho
Posted: Wed Oct 10, 2012 3:37 pm
by harleytrike
whole binacle was changed but still nothing
Re: temp & tacho
Posted: Wed Oct 10, 2012 6:12 pm
by nas80
Can you post pics of both binacle rear circuits?
Re: temp & tacho
Posted: Wed Oct 10, 2012 6:14 pm
by nas80
If you take the under dash panel off. At the back on the right hand side there is an earth point. See if the screw holding it down is loose?
Re: temp & tacho
Posted: Wed Oct 10, 2012 6:16 pm
by nas80
Also have you made sure you plugged everything back in the right place?
Re: temp & tacho
Posted: Wed Oct 10, 2012 6:57 pm
by harleytrike
only unplugged the idle control and air flow meter also get ignition but car wont start then i wait a while and it starts
Re: temp & tacho
Posted: Wed Oct 10, 2012 7:43 pm
by nas80
you might want to clean the plug that goes from the engine to the fuse box.