bmwe21.net forums

Hi, currently in the process of replacing the anti roll bar to control arm bushes.(does anyone have a write up on this by the way ? It was a right t**t getting the roll bar off)

I have'nt got the bushes out of the control arm yet, whats the best way ? Big socket and some threaded bar with bolts ?

I have 2x replacement bushes like the ones in the pic here.


But my question is, are there any other parts other than these to change ? When i took the roll bar off there were circles of shredded rubber hanging off the bar but i dont know what they were originally attached to. They were in front of the big washer at the front where the roll bar enters the control arm. Are these separate parts of some kind ? Ta

I've got this to do soon, I went to BMW and got the washers that go on the bar in front and behind the control arm, and one of the washers (the one that goes in front of the control arm) has a rubber ring around it's edge, presumably to damp any contact between the control arm and the washer. I'm guessing your mystery ring is this, as with rust and wear, it's bound to fall off the washer sooner or later.

Ah, i see. I will have to make another trip to the sales counter. How much did you pay for the washers ? Cheers

£9.30 +vat a pair for the rubber ones, and £8.12 +vat for the others. Not super cheap, but not excessive.

Thats ok i guess. Do you have the part number to hand at all ? Thanks

Rubbery ones are 31351123140

The other ones are 31351121465

Nice one thanks. Dont think i need to replace the other ones. Shud get away wi just new rubber washers. Are you from Sheff btw ?

Yeah just south of Sheffield

Nice one, good to have another Yorkshire car on here