Page 1 of 1

Hubs and headlamps

Posted: Sun Jan 26, 2014 5:53 pm
by polov8
My car has the Big 'n' Little headlamps, and one of the outers has a bit of corrosion on the bottom of the reflector. It's not too bad , and you can't see it in this pic, but it is there:

Image

My question is, are these Bosch H4 lamps unique to the E21 or are they shared with another car. They are the same diameter as mk1 and mk2 Golf lamps but the mountings might be different. Those are easy to get hold of, new or used.

Second question, I read of big and little front bearings, was it only the 323i and 320/6 that used the bigger bearings, and hence would need different hubs? I've got hold of some NOS front struts, part numbers 31311114714 and 31311114715 which I want to completely build up before I fit them to the car, but I'm not sure which bearings and hubs I need to be looking for?

When I look at the RealOEM page for my car (not for these struts which I think are for an earlier car) I see that there are 2 sets of hubs and bearings, the first set seems to match up to the ones for these struts, and the other set is listed as "Tropical version". Is that the 323 variant?

Re: Hubs and headlamps

Posted: Sun Jan 26, 2014 7:56 pm
by Mihajlo
They are the same diameter as mk1 and mk2 Golf lamps and they can be fitted :)

Re: Hubs and headlamps

Posted: Mon Jan 27, 2014 8:18 am
by Jason_323i
bigger bearing hubs needs the matching struts, measure your spindle on the strut and this will define the hub/bearing size