bmwe21.net forums

Posted: **Tue Mar 11, 2014 8:47 pm**

I'm doing a manual conversion on my 316 hope all goes well,one question do I need to use the diff from the manual car? Or can I use my current one

Posted: **Tue Mar 11, 2014 10:05 pm**

Use current one

Just remember the importance of putting the spigot bearing in square. It's a real nightmare if it gets jammed!

Posted: **Tue Mar 11, 2014 10:39 pm**

Do you mean square on the shaft or square in the flywheel? Is it a Fiddly one,

Posted: **Thu Mar 13, 2014 12:48 pm**

Also, double check your prop is the correct length - I've been caught out with that twice now!

Posted: **Thu Mar 13, 2014 4:13 pm**

Defiantly need manual prop, the difference on mine with the m20 was only around 4cm, close enough to look the same at a glance!

Posted: **Thu Mar 13, 2014 5:11 pm**

Im getting the prop from the manual car

Posted: **Thu Mar 20, 2014 7:49 pm**

Swap succesfully ?

Posted: **Thu Mar 20, 2014 7:57 pm**

Yes check out my profile in owners gallery

Auto to manual this weekend