Page 1 of 1
how to .. remove the original rear axle bushing
Posted: Fri Apr 18, 2014 10:46 pm
by gerrit323
I'm in the proces of changing the original back axle bushes by the strongflex PU bushes
The rubber needs to come out of the square metal part .. I've tried .. the center part came out but the sides seem to be molded instead of pressed like the e30 ones
All tips welcome
Re: how to .. remove the original back axle bushing
Posted: Fri Apr 18, 2014 11:24 pm
by nas80
Fire
Re: how to .. remove the original back axle bushing
Posted: Sat Apr 19, 2014 5:32 am
by trash-berd
You could shoot an email to the owner of Eurometric. He takes old subframe bushings as cores and refills them with polyurethane. Ask him how he empties them, lol
Re: how to .. remove the original back axle bushing
Posted: Sat Apr 19, 2014 9:32 am
by polov8
If that pic is of yours, then I'd say look for an old set to destroy and sell those, because they look brand new and cost a fortune from the dealer!
Re: how to .. remove the original back axle bushing
Posted: Sat Apr 19, 2014 9:51 am
by gerrit323
I've stole the picture from PeterV 's topic .. so its not mine
thx for the tips so far
Re: how to .. remove the original back axle bushing
Posted: Sat Apr 19, 2014 9:54 am
by polov8
In that case, destroy it with fire! Muhahahahahaha
Re: how to .. remove the original rear axle bushing
Posted: Sun Apr 20, 2014 9:52 am
by Wondermike
Yup, fire will do the trick but watch the wind direction... my neighbours didn't like my fire
