lengthening M50 TU engine loom
Posted: Mon Jun 15, 2015 1:09 pm
Hey guys,
I am nearing the end of my m50 TU (out of a 94 e34) conversion im just sorting out the loom. I have ran it into the glove box through the body loom port in the fire wall, however its a little on the short side!
So I have a few question.
1: Has anyone lengthened an m50 loom? I was thinking about lengthening the wires inside the box that houses the injector and coil wires as they are the ones that are the shortest, by 150 to 200mm.
2: Is there a difference in engine loom length between e34 and e36 and if the e36 loom is longer can it be uses
On a side note those that have done the conversion on a RHD car, what did you do for a washer bottle?
Also id be happy to put a link up of the pics i have taken thus far I would have already but i figured because its been done so many times before there was no point.
Any help would be greatly appreciated,thanks in advance!
Callan.
I am nearing the end of my m50 TU (out of a 94 e34) conversion im just sorting out the loom. I have ran it into the glove box through the body loom port in the fire wall, however its a little on the short side!
So I have a few question.
1: Has anyone lengthened an m50 loom? I was thinking about lengthening the wires inside the box that houses the injector and coil wires as they are the ones that are the shortest, by 150 to 200mm.
2: Is there a difference in engine loom length between e34 and e36 and if the e36 loom is longer can it be uses
On a side note those that have done the conversion on a RHD car, what did you do for a washer bottle?
Also id be happy to put a link up of the pics i have taken thus far I would have already but i figured because its been done so many times before there was no point.
Any help would be greatly appreciated,thanks in advance!
Callan.