Page 1 of 1
Dumn question. Rear beam bushes?
Posted: Wed Jul 15, 2015 6:39 pm
by healeyneil
Hi all. Ive bought my polyurethane bushes to go in the original casings. My problem is, which side is which. The steel casing measures approx 25mm to the mounting bracket on one side,39mm on the other. You could flip it over to fit either side I believe. W/shop manuals dont make it clear !
Hope I am making myself understood. Thanks, Neil
Re: Dumn question. Rear beam bushes?
Posted: Wed Jul 15, 2015 8:01 pm
by polov8
The mounts go on with the greater side up toward the floorpan, like this pic:
Tried to snap a pic of mine but it was too hard so googled it
Re: Dumn question. Rear beam bushes?
Posted: Wed Jul 15, 2015 11:56 pm
by healeyneil
Brilliant, thanks
Re: Dumn question. Rear beam bushes?
Posted: Thu Jul 16, 2015 6:42 pm
by healeyneil
Fitting the new bushes was easy. I didnt even have to burn out the old rubbers. Another job ticked off
Re: Dumn question. Rear beam bushes?
Posted: Thu Jul 16, 2015 7:36 pm
by Jeroen
