M20B27 Vacuum Line
Posted: Fri Dec 04, 2015 10:59 am
Hi All,
I am planning an M20B27 swap based on an B27 bottom end and 885 head & throttle body.
I am after some advice regarding the vacuum lines for the inlet etc.
I assume it is as simple as running some T's/junctions off the existing servo lines and routing them to the throttle body etc?
Until I sort out some kind of alternative Servo arrangement.
I am planning an M20B27 swap based on an B27 bottom end and 885 head & throttle body.
I am after some advice regarding the vacuum lines for the inlet etc.
I assume it is as simple as running some T's/junctions off the existing servo lines and routing them to the throttle body etc?
Until I sort out some kind of alternative Servo arrangement.