Will these wheels fit?

[Reck]

15" ET13 6.5J

4 studs. 110mm from the center of the top left bolt hole to the center of the bottom right.

Standard ride height on the 316. Will they fit? Quite a way away so don't want to drive down there to find they won't!

Thanks

[e21-Mark]

PCD needs to be 4 x 100 not 110

[Reck]

Ahh, gutted. Thanks for the advice.

Wheels I was interested in; http://cgi.ebay.co.uk/5x-SUPER-7-6-5J-x ... 1c1a5af208

Is it worth looking into PCD adaptors?

[edit] Just seen the price. Sod that, I'll find some that fit.

[drjim]

Come and look at my wheel collection, I have some aftermarket 15" 7J 5 spokes in need of proper refurb that fit and can be yours cheaply. I also have some good condition steelies if you are still interested in them.

[Reck]

Still want the steelies as I'll be on those for winter. I might only need one anyway, so I'll let your expert eyes cast a glance over the other three! I'll definitely have a look at those alloys too. I'm thinking around Easter time will be quiet for me - how about you?

[drjim]

I'm going to be on call Easter weekend but then have the following two weeks off. Might even have the Baur finished by then if all goes according to plan!

[Reck]

I'm free on some weekdays around that time so I'll message you when we're a bit closer.

Nice! Never seen a baur in the flesh so I hope it's done. If you need any help with assembly etc (I might be more talented at brew fetching though) then I wouldn't mind pitching in.