BMW Badge

[nicks85]

Hey all,

I was thinking of getting the badge threaded so that I can use some nuts to screw it down securely.

Or, use some strong glue?

Any ideas?

Cheers

[m3gaz]

I take it we're talking about the roundel on the bonnet or boot.My advice,for what its worth,is to get some new little rubber reseptical grommet type things and just fit it as normal.If some dipshit decides to nick it then there's no damage.Fix it solid and they start with the tools. I've been there courtesy of The Beastie Boys!

[Jeroen]

+1!

[nicks85]

That is a good point.

Any idea what type of glue I could use?

[m3gaz]

No glue,they just sit there and even at 120mph they don't move

[nicks85]

I take it we're talking about the roundel on the bonnet or boot.My advice,for what its worth,is to get some new little rubber reseptical grommet type things and just fit it as normal.If some dipshit decides to nick it then there's no damage.Fix it solid and they start with the tools. I've been there courtesy of The Beastie Boys!

Ok, cool, where can I get hold of some of those rubber resptical grommets?

[Jeroen]

Double topic removed, with 2 grommets from the dealer that set you back abt 2p the badge will be secured in place again. Don't use glue.

[nicks85]

Ok, thanks Jeroen

[nicks85]

Sorted 84p each, will be with me in a couple of days

[nicks85]

I meant 64p each

Should I get some for the rear as well? Seemed to be a little loose

[Jeroen]

Works just the same...