Pic needed front left on full lock

[JTY]

Hi guys

Does anyone have a pic shot from a low angle that shows the left front wheel on full lock towards the right? Preferably 15" wheel...

My e21 is a bare shell at the moment and I'm making up a bracket to fit a competition towing eye. I need a good view on the clearance of the wheel to the front part of the inner wing below the bumper bracket.

Many thanks in advance.

Jeroen T.

[Reck]

While someones there can they take a pic of where the control arm connects to the ARB (at full lock) as I'm not entirely sure my mechanic has installed properly - there's a gap between the washer and the bush which I'm sure should be tight?

[mr edd]

Reck! from memory the side of the control arm that faces the rear of the car(the side with the 22mm roll bar nut ) is normally tight up to the washer and the otherside which is to the front of the car has a gap between the washer and the arm ...if you split the control arm bush while driving the washer at the front stops the arm moveing all over the place ( this happened to me on both sides at the same time and the steering felt a bit loose to say the least !) ...edd

[mr edd]

http://www.factoryworks.com/320%20stuff ... rm%201.jpg

found a pic!

[murran]

ignoring my homemade poly bush insert....

[Reck]

Ahh makes sense! Cheers

Why'd you put a homemade bush there Murran? Just to tighten things up?

(Sorry for the hijack JTY!)

[JTY]

No worries for the hijack Seen what I wanted to see live meanwhile

[murran]

Why'd you put a homemade bush there Murran? Just to tighten things up?

that was the idea, dunno whether its made any difference but i enjoyed making them.