Parts list for my engine swap and a couple of Q's

[Reck]

I'll have a ring round tomorrow. What sort of flexi stuff do I need to be asking for? I asked at a motor factors earlier and they gave me about 10 options.

[mr edd]

I always seem to miss these northern e21 get togethers... i will have to make more effort in future as drjim is the only person from the forum that i have ever crossed paths with..

[drjim]

I have some copper pipe we can use, may also have enough flexi hose too, but it may be too small bore. I used copper for the lines on the slug, it is officially not ideal as it will harden/crack eventually but define eventually!

You need something like 8mm internal diameter high pressure fuel hose.

Murran - I have some cables but I think they are the ones that were too short, or had the wrong ends when we did the Baur - may be for a Golf. We can have a look at them while we are fettling cars in general.

[nas80]

http://www.tangerineracing.com/contact_us.htm

these guys should have some line

[drjim]

Sadly they are in a different Manchester!

[nas80]

lol oopsies

[Reck]

http://www.moss-europe.co.uk/AboutMoss/ ... manchester

Putting this here for future reference.. Do everything we need and says they're open Sat but they haven't picked up the bloody phone all morning!

[murran]

crisis averted...... got some cunifer pipe! andrew pages had some! £28.13

[drjim]

Been to the unit, engine is on a pallet wrapped in plastic, didn't unwrap!

[Reck]

crisis averted...... got some cunifer pipe! andrew pages had some! £28.13

Lifesaver!! I actually found an Andrew Page not far from here but only at 12.15 and they shut at half past!

I got a metre of 8mm high pressure flexi fuel hose from a motor factors too.

Nice one Jim.. Did that spare ECU arrive?