Hello all, I'm after a little help with my motronic conversion. I have removed the injection from an e34 525i m20 and installed it on my standard 323i m20 which had the k jetronic on it. Well the problem is I started this about 9months ago and before I had finished it a few other dramas turned up and wasn't able to finish it until recently, anyway all the wiring is done and the car runs but I cant remember what connects to the large outlet on the side of the throttle body. It is the large tube which faces the front of the car. I have currently plugged the tube but I would rather connect it to the correct spot. I did take a few photos when removing the injection but none that clearly show what goes where. Anyway thanks in advance hope someone can help.
Also any ideas on what others have done with running the throttle cable?
motronic help required
Re: motronic help required
Thanks Jeroen, but I do have the idle control valve, the actual tube is directly under the piping for the icv hence the reason I cant tell from the photos as it is hidden a bit by the icv. The tube that sticks out in approx 8mm in diameter. Thanks again for the quick reply
Re: motronic help required
It'll be the pipe which goes to the rocker cover. Oil Breather I think?
Ben
Ben
1982 323i ("Test Mule" - to become an M20 powered track car)
1983 316 (Taiga Thunder - S54 Track car)
1982 635csiA (Another Weldathon)
2004 330d Touring (The Daily Hack / Tow Car / Load lugger)
1974 3.0 csi (The first Weldathon)
1983 316 (Taiga Thunder - S54 Track car)
1982 635csiA (Another Weldathon)
2004 330d Touring (The Daily Hack / Tow Car / Load lugger)
1974 3.0 csi (The first Weldathon)
Re: motronic help required
That's a possibility I'll check it out tonight, thanks.
Re: motronic help required
Yes!! that was the one it made sense as so as I saw it, can't believe I couldn't work it out. Thanks gotta love this forum!