Am I right in assuming this special washer goes on the nut side of the control arm/wishbone with the rubber ring facing the control arm?
ARB fitting
-
AndyBaur
- E21 Fanatic
- Posts: 282
- Joined: Thu Apr 21, 2011 11:10 pm
- My E21(s): 1983 320/6 Baur 5-speed (now gone)
- Location: 55* North
ARB fitting
When I pulled off my anti roll bar I failed to notice that one of the two large washers at each end had a rubber ring around the perimeter of one face.
Am I right in assuming this special washer goes on the nut side of the control arm/wishbone with the rubber ring facing the control arm?
Am I right in assuming this special washer goes on the nut side of the control arm/wishbone with the rubber ring facing the control arm?
AndyS
Live each day as if it's your last because one day it will be.
Live each day as if it's your last because one day it will be.
-
Jeroen
- Site Admin
- Posts: 29994
- Joined: Tue Sep 14, 2004 12:23 pm
- My E21(s): '81 323i Baur
- Location: The Netherlands
- Contact:
Re: ARB fitting
Correct, that's where they could cause clunks hitting the control arm.
Regards/groeten, Jeroen
